Transparencies
Transparencies can be fed from Trays 1- 5 (Bypass). Stripeless transparencies are recommended. Striped transparencies must be loaded in Trays 1 - 4 with the stripe face down, on the right side of the tray. For Tray 5 (Bypass) striped transparencies must be loaded with the stripe face up, on the left side of the tray.
NOTE: Use only the transparencies recommended in the Recommended Materials for the DocuColor Series.
After loading the transparencies you can program the copier printer to insert a blank separator page between transparencies by using the Transparency Separators feature.
For more information about the Tranparency Separators feature, refer to the section entitled Transparency Separators, in this chapter.
Follow these guidelines to prevent static build up when using transparencies:
•Place no more than twenty 8.5x11 inch or A4 transparencies in Tray 5 (Bypass) at one time.
•Place only one 11x17 in. or A3 transparency in Tray 5 (Bypass) at a time.
•Remove the transparencies from the Center Output Tray before running additional sets.
•It is not recommended that you output more than 20 transparencies at a time. If your job is larger than 20 pages, use the Transparency Separators feature.
NOTE: Transparencies cannot be delivered to the Finisher Tray.
For more specific information about materials that have been tested and approved for use in the DocuColor 3535, refer to the Recommended Materials for the DocuColor Series. Current information is also available at the Xerox web site.
5– 6 | Xerox DocuColor 3535 Printer/Copier |
