Stapler Faults
This section describes how to clear stapler faults. Follow the procedures on the following pages when copies are not stapled or when staples are bent.
NOTE: To staple copies, the Finisher (optional accessory) must be installed.
1 Make sure that the machine has stopped, then open the front cover in the Finisher.
2 Hold the staple cartridge by its lever, and pull the staple cartridge out to the right toward you.
3
4
Lift up the staple cartridge to remove it.
After removing the staple cartridge, check the inside of the Finisher for any remaining staples.
5
6
Pull up the lever on the front of the staple cartridge.
Remove the jammed staples together with the staple sheet.
NOTE: When removing jammed staples, also remove the staple sheet. Do not remove unused staples from the staple cartridge.
WARNING: Be careful when removing jammed staples to avoid hurting your fingers.
7 Close the lever on the front of the staple cartridge until you hear it click into place.
8 Return the staple cartridge to its original position until you hear it click into place.
9 Close the Finisher front cover.
NOTE: A message will be displayed and the machine will not operate if the Finisher front cover is not closed completely.
7– 1 0 | Xerox DocuColor 3535 Printer/Copier |
