SETTING THE SYSTEM CONFIGURATION
•
•
•
•
•
This is set within a FORMDEF via the PROCESSING keyword in the PPFA. The range is a hexadecimal value from 0000 to FFFF. You will need to obtain these values from the job or the applications programmer.
Statuses Supported (p7) — Specifies the status indicators that are supported by the third party finishing device. You can check all status indicators that apply. The selections are as follows:
—Not Ready
—Faulted
—Full
—Sheet Delivered
—Set Delivered
Delivery Signal Type (p8) — Specifies the type of signal that can be delivered. You can select one of the following:
—Leading Edge
—Trailing Edge
Delivery Signal Start Adjust (ms) (p9) — Specifies the timing of the start of delivery signal. You can enter the value or set it with the incremental spin boxes. The range is
Delivery Signal Duration (ms) (p10) — Specifies the timing of the End of Delivery signal. You can enter the value or set it with the incremental spin boxes. This value corresponds to the width of the sheet. You specify this value only when you select Trail Edge for the Delivery Signal Type. The range is 30 to 110 milliseconds.
Sheet Exit to End of Set Time (ms) (p11) — Specifies the time required between the EndOfSet signal and the SheetExit signal. You can enter the value or set it with the incremental spin boxes. The range is 0 to 255 milliseconds.
4.Click the Add button when finished. The File Name Entry window displays.
Figure 4-51. File Name Entry window
5.Enter the name for the new DFA profile. Be sure to use a name that will help you remember which
6.Click OK to return to the Output DFA Profile window.
7.Click Save to save the new DFA profile.
XEROX DOCUPRINT 92C IPS GUIDE TO CONFIGURING AND MANAGING THE SYSTEM |
