Yamaha MOTIF6, MOTIF7, MOTIF8, Music Production Synthesizer • Speed, • Delay, 2LowGain (Low Gain), 4HighGain (High Gain), 1LowFreq (Low Frequency), ● [F5] Plug-inElement LFO, 3HighFreq (High Frequency)

● [F5] Plug-in Element LFO

Basic Structure (page 47)

From this display you can set the basic LFO parameters for modulating the pitch to create vibrato and other special effects.

• Speed

Determines the speed of the LFO waveform. Positive settings increase the speed and negative settings decrease it. This is applied as an offset to the same parameter in the original voice of the Plug-in board.

❏ Settings	-64 ~ 0 ~ +63
Speed=slow	Speed=fast

Time Time

• Delay

Determines the delay time between the moment you press note on the keyboard and the moment the LFO comes into effect. Positive settings lengthen the delay and negative settings shorten it. This is applied as an offset to the same parameter in the original voice of the Plug-in board.

❏ Settings	-64 ~ 0 ~ +63
Short Delay	Long Delay

Key on Key on

• PMod (Pitch Modulation Depth)

Determines the amount by which the LFO waveform controls the pitch. Positive settings increase the amount and negative settings decrease it. This is applied as an offset to the same parameter in the original voice of the Plug-in board.

❏ Settings -64 ~ 0 ~ +63

●[F6] Plug-in Element EQ (Equalizer)

From this display you can apply equalizer settings to the Board voice. This is a shelving equalizer with two bands; one for high frequencies and the other for low frequencies.

Voice Edit mode

+
0
					Frequency
-
	1		3	4
2	LowFreq		HighFreq	HighGain
LowGain
1LowFreq (Low Frequency)
Determines the shelving point for the low frequencies.
The levels of signals below this frequency will be boosted/
attenuated by the amount set in the LoGain parameter.
❏ Settings		32Hz ~ 2.0kHz
2LowGain (Low Gain)
Determines the amount by which signals below the
LoFreq frequency will be boosted/attenuated.
❏ Settings		-64 ~ 0 ~ +63
3HighFreq (High Frequency)
Determines the shelving point for the high frequencies.
The levels of signals above this frequency will be boosted/
attenuated by the amount set in the HiGain parameter.
❏ Settings		500Hz ~ 16.0kHz
4HighGain (High Gain)
Determines the amount by which signals above the HiFreq
frequency will be boosted/attenuated.						mode
❏ Settings		-64 ~ 0 ~ +63
◆ About Board Custom Voice Editing						Voice
						Reference
You can edit Board Custom voices of the Plug-in Board

by using the Voice Editor software included with the board.

nSelect the Part Number of the Editor software to “1” when using the software with the Voice mode. Also make sure to match the basic MIDI receive channel of the MOTIF (page 258) to the MIDI channel of the Editor software.

The original Board Custom voices you’ve edited can be saved and controlled from the computer.

Make sure to save the edited data to a memory card or connected SCSI device from the MOTIF, since any edited data in the DRAM of the Plug-in board will be lost when you turn off the power on the MOTIF.

nFor details about how to use the Voice Editor software included with the Plug-in board, refer to the Online help of the Voice Editor.

nEditing the above parameters may or may not have much effect on the sound, depending on the particular Plug-in board you've installed.

MOTIF Reference 157