Installing Optional Hardware

Flip over the AIEB2 taking care not to bend or damage the flat ribbon cable.

AIEB2

Installing the mLAN8E

1 Using the same procedure as in steps 1 - 4 of “Installing the AIEB2” above, remove the cover on the underside of the MOTIF, then remove the cover of the mLAN/I/O expansion bay.

2 Remove the mLAN8E from its package and connect the included flat ribbon cable. Securely fasten the flat ribbon cable to the rear panel of the mLAN8E. Make sure that the ribbon is at the bottom, as shown.

Top of mLAN8E

10 Let the ribbon cable fall into place between the AIEB2 and the circuit board of the MOTIF.

 

Slide the flat ribbon cable

 

in the space between the MOTIF

Underside of the MOTIF

and the AIEB2.

 

AIEB2

Rear panel of the MOTIF

Underside of the MOTIF

AIEB2

Rear panel of the MOTIF

11Re-install the cover you removed in earlier steps, in reverse order.

Appendix

Make sure that flat ribbon cable is at bottom of connector.

Rear panel of mLAN8E

Front panel of mLAN8E

Make sure the flat ribbon cable sticks out from the bottom and that the panel printing "mLAN8E" can be seen.

3 Hold the mLAN8E upside down, and insert the connector on the other end of the flat ribbon cable, to the circuit board of the MOTIF.

Align the connectors as shown.

Underside of the MOTIF

CN5

Underside of mLAN8E

Rear panel of the MOTIF

Front panel of mLAN8E

(This example illustration shows the MOTIF6/MOTIF7.)

286MOTIF Appendix