Sampling Standby

The explanations here apply to step #6 of the Basic Procedure on page 234.

Indicates the MOTIF is in the Sampling Standby mode.

• TriggerMode

Specifies the method by which sampling will be triggered.

❏Settings level

Sampling will begin as soon as an input signal exceeding the specified trigger level is received after the [F6] (START) button is pressed.

When this is selected, you need also set the Trigger Level (1~127).

meas

This is available only when entering the Sampling mode from the Song/Pattern mode and should be set together with the Punch-in/out measure.

After the [F6] (START) button is pressed, sampling will begin at the specified punch-in measure, and end at the specified punch-out measure. Sampling will also stop when the Song/Pattern is stopped by pressing the [■] button.

manual

Sampling will begin as soon as the [F6] (START) button is pressed, regardless of the Song/Pattern playback status.

• RecMonitor (Recording Monitor)

Determines the output level of the monitor for the input signal.

This monitor signal is output from the PHONES jack or the OUTPUT R and L/MONO jacks. This has no effect on the recording level.

❏ Settings 0~127

•RecGain (Recording Gain)

Determines the recording gain when resampling.

This parameter is available only when the Source is set to “resample.”

❏ Settings -12dB~+12dB

Sampling Record mode

Trigger Waiting

The following display applies to step #7 of the Basic Procedure on page 234. The following display is available when the Trigger mode is set to “level.” In this case, sample recording is on standby, waiting for an input signal that exceeds the Trigger level.

Indicates that sample recording is waiting for a signal of an appropriate level.

Punch-in Waiting

The following display applies to step #7 of the Basic Procedure on page 234.

The following display is available when entering the Sampling mode from the Song/Pattern mode and when the Trigger mode is set to “meas.” In this case, sample recording is on standby, waiting for song/pattern playback to reach the specified Punch-in measure.

Indicates that sample recording is waiting for a signal of an appropriate level.

Slice setting after sampling

The explanations here apply to step #9 of the Basic Procedure on page 235.

If you’ve entered the Sampling Record mode for the Song or Pattern mode and you’ve set the sampling type

to “slice+seq,” you should set the following Slice-

mode

 

related parameters.

Sampling

■ [F1] Trim

 

The trim function makes it possible to specify the

Reference

beginning and end points to be played back within an

 

entire sample. You can delete all unnecessary sample

 

data (located ahead of the Start point and located after

 

the End point) by pressing the [SF5] button (Extract

 

function). This function is especially useful in creating

 

drum loops, since it helps you isolate only the beats

 

you need for your loop.You can also specify the tempo

 

for the range of the looped playback to determine its

 

beat.

 

MOTIF Reference 237