When Trigger mode is set to Meas :

Sampling Standby

Press the [F6] button.

Punch-in Waiting

Start playback of the song or pattern. When the appropriate Punch-in measure is reached, sampling starts.

Sampling Start

When the appropriate Punch-out measure is reached, sampling stops. Otherwise, to stop sampling, press the [F6] button.

Sampling Stop

8 Stop the Sampling following the instructions above and stop the recording source playback.

9 Set the Slice parameters as needed— if you’ve entered the Sampling Record mode from the Song/ Pattern mode, and you’ve set the Sampling type to “slice+seq” in step #5 above.

10Save the recorded sample to the memory card/ SCSI storage device as a Waveform, User voice, or Sample voice, as required.

The recorded (edited) phrase data resides temporarily in DRAM (page 64). Because data contained in DRAM is lost when the power is turned off, you should always save any data residing in DRAM to a memory card or an external SCSI device before turning off the power.

•The operations corresponding to steps #4 - 9 are covered in the following explanations.

•For details on step #10, refer to “File mode” on page 264.

Sampling Setup

The explanations here apply to steps #4 and #5 of the Basic Procedure on page 234.

■[F1] Sampling Destination settings

The explanations here apply to step #4 of the Basic Procedure on page 234.

●When entering the Sampling mode from the Voice/Performance mode

nThe MOTIF can transfer wave data to and from the computer (with TWE software) only when this display is called up.

Sampling Record mode

• Waveform

Determines the Waveform number to which the recorded sample is assigned.

❏ Settings 001~256

•Keybank

Determines the note number located at the center of the Key Bank.

❏ Settings C-2 ~G8

nFor details about the Waveform and Key Bank, see page 60.

•Part

Determines the performance part to which the recorded sample is assigned. This is available only when entering the Sampling mode from the Performance mode.

❏ Settings off, 1~ 4

• Voice

The recorded sample can be stored as a User Normal voice. This parameter determines a User Normal voice number to which the recorded sample is assigned.

❏ Settings off, 1~128

nWhen this is set to “off,” only a Waveform is created; the sample is not stored as a User voice. The sample is stored to the smallest numbered Waveform available. If you wish to hear the new sample and later assign it to a User voice, go to the Element Oscillator display ([F1]-[SF1]) in the Voice Edit mode and search the User Waveforms to find the sample. For details, see page 135.

●When entering the Sampling mode from the Song/Pattern mode
• Track

 

mode

Determines the track number to which the recorded

sample is assigned.

Sampling

❏ Settings

1~16

 

• Keybank

 

Reference

Type parameter below).

Determines the note number located at the center of the

 

Key Bank. This parameter is available only when the

 

Sampling type is set to “sample” or “sample+note” (in the

 

❏ Settings

C-2~G8

 

MOTIF Reference 235