Installing Optional Hardware

4MB X 2

Internal memory

4MB

12MB can be used for sampling.

16MB X 2

Internal memory

4MB

36MB can be used for sampling.

8MB X 2

Internal memory

4MB

20MB can be used for sampling.

32MB X 2

Internal memory

4MB

64MB can be used for sampling.

Installing the SIMM modules to the sockets

Tilt the SIMM and insert it into the socket.

Push the SIMM up vertically.

Cutout

nMake sure that the SIMM is securely inserted in the

socket of the MOTIF. Inserting the SIMM improperly or

incompletely may result in faulty operation.

* To remove the SIMM, gently but firmly pull the fastening

•Yamaha recommends that you purchase SIMMs that conform to the JEDEC* standard. Please be aware, however, that conformance to this standard does not constitute a guarantee that the SIMMs will operate correctly on the MOTIF.

•JEDEC (Joint Electron Device Engineering Council) sets standards for terminal configurations within electronic devices.

SIMM Installation

1Use the same operation as in “Installing the AIEB2.”

2 On the SIMM, there is a cut in the board next to the 1PIN. Insert the board into the socket so that the 1PIN lines up with the 1PIN mark (▲) printed on the board.

72PIN SIMM

Cutout

Location for SIMM Installation

 

to

 

to JK

to PS

4

CN24

11

CN25

4 CN23

1PIN mark

SIMM sockets

clips open, then tilt the SIMM back and pull it out.

Pull open these clips.

Pull open these clips.

Tilt the SIMM module and pull it out.

3 Set the SIMM into the socket at an angle as shown in the illustration above (1). Then push the SIMM upright until it clicks into the position shown in figure

4 Insert the remaining SIMM into the remaining socket.

5 Re-install the cover you removed in earlier steps, in reverse order.

6 Check that the installed SIMMs are functioning properly. Set the MOTIF right-side up, and connect the power cord to the rear-panel AC INLET jack and an AC outlet. Turn on the power, go to the SAMPLING display, and press the

Appendix

Underside of the MOTIF Rear panel of the MOTIF

[INFORMATION] button (page 276). If the SIMMs have been installed properly, the appropriate available memory size is indicated in the display.

288MOTIF Appendix