Utility Job mode

●[F6]-[SF2] Plug-in board MIDI

From this display you can set various MIDI-related parameters for the Plug-in board.

• DevNo (Device Number)

Determines the MIDI Device Number of the Plug-in Board. This number must match the Device Number of the external MIDI device when transmitting/receiving bulk data, parameter changes or other system exclusive messages to/from it.

❏ Settings 1~16, all, off

• PORT NO. (Port number)

Determines the MIDI Port number over which the Plug-in board receives MIDI data.One port can be set for the Multi-part Plug-in board and two ports can be set for the Single part Plug-in board.

❏ Settings off, 1~3

nThe Port number for the Effect Plug-in board (VH) is fixed to 1.

•GM/XG

Determines whether “GM on” and “XG on” messages are recognized (on) or not (off) . This parameter is available only when the Multi-part Plug-in board has been installed to slot 3.

❏ Settings on, off

●[F6]-[SF3] Plug-in boardNative System Parameters (Slot 1)

From this display you can set the Native System parameters of the Plug-in board installed to slot 1.

For details on these parameters, refer to the owner’s manual of your particular Plug-in board.

Reference

● [F6]-[SF4] Plug-in board

 

 

Native System Parameters (Slot 2)

 

From this display you can set the Native System

Utility

parameters of the Plug-in board installed to slot 2.

For details on these parameters, refer to the owner’s

 

mode

manual of your particular Plug-in board.

● [F6]-[SF5] Plug-in board

 

 

Native System Parameters (Slot 3)

 

From this display you can set the Native System

 

parameters of the Plug-in board installed to slot 3.

 

For details on these parameters, refer to the owner’s

 

manual of your particular Plug-in board.

Utility Job mode

In this Mode, you can restore your MOTIF’s User memory (SRAM, see page 64 ) to the factory default settings (Factory Set).

When you restore the factory default settings, all the current settings for all the User voices and performances on the User Memory will be overwritten with the factory defaults.

Make sure you are not overwriting any important data. You should back up any important data to memory card/SCSI device beforehand.

◆Factory Set (Restore Factory Defaults)

1 In the Utility mode, press the [JOB] button to enter the Utility Job mode.

2 Press the [ENTER] button. (The display prompts you for confirmation.)

3 Press the [INC/YES] button to execute the Job. After the Job has been completed, a “Completed” message appears and operation returns to the original display.

nTo cancel the Job, press the [DEC/NO] button.

4 Press the [UTILITY] button to exit from the Utility Job mode back to the Utility mode.

nAll settings in the Utility mode that are related to the Plug-in boards and the mLAN8E are stored only to the memory on those respective devices, and not to the User memory of the MOTIF. Because of this, the Factory Set operation cannot be used to restore settings for those devices.

260MOTIF Reference