AT-GS950/16PS Switch Web Interface User’s Guide
Disable a Port Trunk
This procedure explains how to disable a port trunk.
Caution
Before you disable or modify a port trunk, disconnect all of the cables from the ports of the trunk. Leaving the cables connected during the reconfiguration of a trunk can create loops in your network topology. Loops can result in broadcast storms which can severely limited the effective bandwidth of your network.
To disable a port trunk, perform the following procedure:
1.Disconnect all of the Ethernet cables from the ports of the trunk.
2.Select the Bridge folder. The Bridge folder expands.
3.From the Bridge folder, select the Trunk Config folder. The Trunk Config folder expands.
4.From the Trunk Config folder, select Trunking.
The Trunking Page is shown in Figure 31 on page 97.
5.To disable a port trunk, select Disable from the
6.Click Apply.
7.From the main menu on the left side of the page, select Save Configuration to Flash to permanently save your changes.
8.Modify the port trunk configuration in the same way on the other switch.
101
