Allied Telesis AT-S112, AT-GS950/16PS manual IP Access List Configuration, Create an IP Access List

Chapter 2: System Configuration

IP Access List Configuration

Create an IP Access List

When the IP Access List feature is enabled, remote access to the AT-S112 management software is restricted to the IP addresses entered into the IP Access List.

The procedures in this section describe how to enable or disable the IP Access List feature and how to add or remove IP addresses from the list. See the following sections:

“Create an IP Access List” on page 32

“Delete an IP Address List Entry” on page 33

Note

To modify IP address that has already been created, it must first be deleted and them re-created using the following procedures.

To create a list of accessible IP addresses, perform the following procedure:

1.From the main menu on the left side of the page, click the System folder.

The System folder expands.

2.From the System folder, select IP Access List. The IP Access List

Page is displayed. See Figure 7.

.

Figure 7. IP Access List Page

3.Enter an IP address in the IP Address field using a xxx.xxx.xxx.xxx format.

4.Click Add.

The IP address is added to the IP Access List table in the Accessible IP column.

Note

You can add up to 10 IP address to the IP Access List table.

32