Allied Telesis AT-S112, AT-GS950/16PS manual Snmp Traps, Create Trap Host Table Entry

Chapter 16: SNMPv1 and v2c

SNMP Traps

Create Trap Host Table Entry

A Host IP address is used to specify a management device that needs to receive SNMP traps sent by the switch. This IP address is associated with the SNMP Version and a valid Community Name in the Host table of the switch.

Use the following procedure to create a trap Host table entry:

1.From the main menu on the left side of the page, select the SNMP folder.

The SNMP folder expands.

2.From the SNMP folder, select Trap Management.

The Trap Management Page is displayed. See Figure 67.

Figure 67. Trap Management Page

3.Enable trap management by selecting the radio button next to Enabled at the top of the page.

By default, trap management is enabled.

4.Enter the Host IP Address for the management device that is to receive the SNMP traps.

The IP address must be in the xxx.xxx.xxx.xxx format.

5.Enter the SNMP Version, either v1 or v2c, that is configured for the host management device.

6.Enter a Community Name that you have defined previously in the SNMP Community table.

198