Allied Telesis AT-S112, AT-GS950/16PS manual Configuration Example

Chapter 7: LACP Port Trunks

Configuration Example

The System Priority is a preassigned value that you cannot alter. This value applies to the switch. See “System Priority” on page 105.

The System ID is a MAC address value assigned to the individual switch. You cannot change this value.

Group 1 to 8 indicates the ID number of the trunk (aggregation group).

Use the procedure given in “Create a Port Trunk” on page 97 to configure Trunk ID 1 as Active with ports 3, 4 and 5.

The LACP Group Status Page is updated. This configuration is shown in Figure 33 before the Ethernet cables are connected.

Figure 33. LACP Group Status Page with No Cables Connected

4.Physically connect the network cables between the switch and a second LACP device which is pre-configure with an LACP activated trunk of three or more ports.

The LACP Group Status Page is updated. An example of these updates is shown in Figure 34 on page 111 after three trunking cables are installed and the ports have Link-Up status.

110