Chapter 2: System Configuration
4.In the Local Time Settings section, set the Date Setting (YYYY:MM:DD) to the current date in the YYYY:MM:DD format.
5.In the Local Time Settings section, set the Time Settings (HH:MM:SS) to the current time in the HH:MM:SS format.
6.Click the Apply button at the bottom of the page. The time will take effect immediately.
7.Save your new settings or any changes to the configuration file by selecting Save Configuration to Flash from the main menu on the left side of the page.
Setting SNTP To configure SNTP, perform the following procedure:
1.From the main menu on the left side of the page, click the System folder.
The System folder expands.
2.From the System folder, select System Time.
The System Time Page is displayed. See Figure 11 on page 39.
3.Use the pull down menu to set the Clock Mode parameter to SNTP.
4.Enter the IP address of the SNTP Primary Server. The format is xxx.xxx.xxx.xxx.
5.Enter the IP address of the SNTP Secondary Server. The format is xxx.xxx.xxx.xxx.
6.Enter the SNTP Poll Interval. The range is 1 - 60 minutes.
7.Enter the local Time Zone from the pull down menu.
8.Click the Apply button at the bottom of the page.
The switch will immediately start polling the SNTP primary server for time information.
9.Save your new settings or any changes to the configuration file by selecting Save Configuration to Flash from the main menu on the left side of the page.
40
