Belkin user manual Configuring the KVM IP devices in the OmniView IP 5000HQ, Advanced button

Management

Table of Contents sections 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

8..4 Configuring the KVM IP devices in the OmniView IP 5000HQ

Configure a new KVM IP device as follows:

1.In the “New Devices” section, click the MAC address of a KVM IP device. The “General” tab of the “Devices” page appears; see Figure 53.

Status – This is the connection status.

Device Info – Contains information about the device, including its operational status and version numbers of firmware, KME (keyboard, mouse emulation), hardware, SDF (switch definition file), and date and time of last configuration update.

8..4..1 The Advanced button

When required, you can change the performance and mouse settings (the “Set mouse and performance from KVM over IP Session” must be unchecked on the “Settings/Global Settings” page—see the “OmniView IP 5000HQ session idle time-out” section on page 50).

To do so:

Press . The following appears:

Figure 53 KVM-over-IP Devices page – General tab
Type – KVM IP device type, OmniView IP 5232K, etc. (read-only field).	Figure 54 KVM-over-IP device – Advanced page
Name –You must assign a unique name to each IP device before
associating connected targets or KVM switches. Type a name for
the device.
Description – These are optional fields used for device identification.

OmniView IP 5000 HQ 37