40
OmniView IP 5000 HQ
sections
table of contents 1 3 5 7 9 11 13 15 17 192 4 6 810 12 14 16 18 20 21
15
ManaGeMenT
8.6 Targets
The targets you created appear in the “Targets” list.
You can choose to display all targets or just unassigned targets (default), or
targets belonging to a target set. Select the desired option from the “Show
Targets” drop-down menu.
You must associate the targets with the relevant IP device or with the port
numbers on the KVM s witch to which they are physically connected.
To associate the targets:
1. From the “Targets” list, double-click the target conn ected to port #1
of the KVM switch. The target assigns to port #1 of the “Ports” secti on.
Alternatively, drag and dr op the target to t he correct por t number.
2. Repeat the above s tep for all targe ts connected. En sure the right t arget
assigns to the correc tly numbered po rt.
To remove a target from a por t:
Double-click the target in the “Ports” section. The target name moves to
the “Target” section and is now unassigned.
note! Deleting a target removes its association with the KVM port number.
8.7 network tab
In the “Network” tab, you configure and modify network parameters of the
IP device.
Click the “Network” tab. The following appears.
Figure 56 KVM-over-IP Devic e – Network ta b
Interface I displays the IP address of the KVM-over-IP device as discovered
by the OmniView IP 5000HQ Manager system. You can change this
address here.
Enter IP address, subnet mask, and default gateway for the network
adapter, as given by your network administrator.
In “TCP Ports”, type three ports (from 800 and up to 65535). By default the
port numbers are 900, 901, and 902. These default ports are suitable for the
majority of installations.