Configuring Targets
Table of Contents sections 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
2.From the toolbar, click 
. The “New Target” page appears; see Figure 26.
Name – Type a unique name for each server in the system.
7..1 Access Services tab
Here you select and configure all Access Services relevant to this target.
All Services/Active Services: From the “All Services” list, select the check box of all Access Services relevant to this target. Once selected, the service appears in the “Active Services” list.
Note! Below discusses how to configure Belkin IP devices. Configuring other Access Services is discussed in the “Configuring Access Services for Individual Targets” section on page 67.
The
7..1..1 Default Access Service
You can set any of the Access Services to be the default service. This means that the service will be used to access the target by default when selecting the target by clicking its name. To access the target via a different service, the service must be selected. To set a service as the default, display the service as explained below and select the “Set as Default Service” check box, circled in Figure 26.
Figure 26 Creating a New Target – Access Services tab
OmniView IP 5000 HQ | 23 |
