Belkin 5000HQ user manual Adding new console servers Serial tab

Management

Table of Contents sections 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21

Figure 51 Adding new console servers – Serial tab

Drag the target name from the right side’s current targets list to the left side’s corresponding serial port. Double-click on the target name on the right side to remove the selection. Repeat for each power outlet,

and clickwhen you’re done. Your console server has been configured and the console server ( ) becomes available from the “Access” tab.

Figure 52 Using console servers

8..3 Setting each OmniView KVM-over-IP Switch to be OmniView IP 5000HQ-enabled

In order to be managed by OmniView IP 5000HQ, all Belkin KVM IP devices must be configured to be HQ. See the “Setting Up the System” section on page 10.

Tip! Since KVM IP devices only appear in the “New Devices” list once they are HQ-enabled, make each KVM IP device HQ-enabled in a certain order with a suitable time gap, so that you can identify the unit’s location.

OmniView IP 5000 HQ 36