•
•
111
Statistics reporting. Statistics for the CrossLink are displayed for individual ports, not for the CrossLink as a whole. Station addresses are distributed among the ports in the CrossLink. See Chapter 7, “Monitoring the Network from the Console Statistics Menu”.
Address filtering. Address filters are automatically added to every port in a CrossLink.
The port with the lowest number configured in the CrossLink is called the base port. The active port with the lowest number is selected as the primary port. The CrossLink software learns addresses differently than regular ports, as follows:
•
•
•
•
New source address. When a packet arrives at a CrossLink port with an unknown source address, the system module creates an entry in the master table and the port table for the CrossLink. The system module assigns the primary port in the CrossLink as the location of the address.
For additional source addresses, the system module assigns locations alternately to other ports in the CrossLink. When all ports in the CrossLink have at least one address assigned, the system module starts assigning from the primary port again.
New destination address. An unknown destination address packet is sent out on the primary ports of the CrossLink, but entries are not made in ports tables until a reply packet comes back. Entries in port tables depend upon the destination. See the description of primary ports on page 114.
Broadcast and multicast packets. Broadcast and multicast packets go to the primary port of each CrossLink.
Link failure. If one link in a CrossLink fails, a trap is sent, and the CrossLink connection continues with the rest of the links. If the link that is going down is the primary port, a new primary port will be selected instead.
Switch Configuration | SmartStack |
