Back panel of the STS16-20R | Cabletron Systems STS16-20D specs

64

Figure 22. The back panel of the STS16-20R

4.Verify that the power LED is on. If not, make sure the outlet is working properly. If the outlet is working, but the power LED and the fans are not on, see Chapter 10, “Troubleshooting”.

5.When the SmartStack STS16-20D/STS16-20R powers on, observe the self-testdiagnostic that the unit runs for approximately 1-2 minutes. The DIAG LED is on for the duration of the test, turning off when the self-test is complete.

6.At the completion of the diagnostics, the front panel LEDs should be illuminated according to the status of the unit’s configuration. See the following sections for a description of the controls and LEDs for the SmartStack STS16- 20D/STS16-20R.

➽Note: If the SmartStack STS16-20D/STS16-20R fails to power up correctly or if it encounters any unrecoverable error, the ERR LED will be on or flashing on. If the ERR LED is on or flashes, see Chapter 10, “Troubleshooting”.

➽Caution: If you are using the SmartStack STS-PSU Redundant Power Supply Unit on STS16-20R, note that this unit is not hot-swappable.

SmartStack STS16-20D/STS16-20R Token Ring Switches Installation and User Guide

Installation

Image 78

Cabletron Systems STS16-20D manual Back panel of the STS16-20R

Contents

Page Page Order Number 9032956-01 OC-7054 v .1 FCC Notice Vcci NoticeIndustry Canada Notice Declaration of Conformity Addendum IiiApplication of Council Directives 89/336/EEC 73/23/EEC Table of Contents Preparing for Installation Installation Accessing Switch Management Switch Configuration Monitoring the Network from the Console Statistics Menu 155Vii Monitoring Port Traffic 211 Troubleshooting 215Monitoring the Network with Snmp 201 Viii Getting in Touch with Technical Support 221 List of Figures List of Tables Xii SmartStack STS16-20D Token Ring Switch Introduction Switching Technology Switch of Switches Switch of Servers Switch of HubsSwitch of Desktops Switch of Floors and Buildings Switch of Routers Front Panel Details Management PortToken Ring Ports Reset Button Switched Port AnalyzerSystem Request Button Labels Status and Activity LEDsState Meaning Lists the port LEDs and their meanings Lists the stack-link LEDs and their meaningsConnection has been established to the stack Token Ring port is inserted into the ring Back Panel Details Back panel of the switches are illustratedLists the back panel connectors on the switch Name Description Features and Specifications FeaturesPerformance and Advanced Features Management Scalability and High Availability Installation Specifications Capacity Performance Specifications Performance Physical Characteristics Support On SmartStack Specification Value Protocol compatibilitySpanning Tree Protocol STS16-20D only for Ports 17 to MIBs supported Switch Overview Multiple Simultaneous Conversations Low Latency SmartStack STS16-20D Token Ring Switch SmartStack STS16-20R Token Ring SwitchAddress Management Multiple Bridging Modes Source Route Switching SRS Source Route Bridging SRB Source Route Transparent SRT SRT/SRB Filtering Congestion Control Store and Forward Three Switching ModesCut-Through Auto Adaptive Cut-Through Token Ring Port Operation Modes RI/RO-Like Connection on SmartStack STS16-20R Transmission Priority Queues ClearSession Support CrossLink Connections Spanning Tree Protocol Support Vlan Support Vlan Dynamic Source Route Recovery Example of Dynamic Source Route Recovery, Base Configuration Example of Dynamic Source Route Recovery, Normal State Example of Dynamic Source Route Recovery, Switch 1 Failed Specification Management SmartStack Manager for Windows Telnet Management and VT100 Management ConsoleIBM LAN Network Manager Rmon Support Name Support Info Event Back-to-Back Built-in Port CountersStackable Architecture Internal Stacker Optional Redundant Power Supply on SmartStack STS16-20R Preparing for Installation Safety RecommendationsSafety with Electricity Preventing Electrostatic Discharge Damage Site Requirements Chassis AccessibilityPower Environment Preparing for Installation Configuration Guidelines Frame Length Limit Ieee 802.1D Spanning Tree Ring Numbers Sample Uses of the SmartStack STS16-20RM Family Switches Typical Network without the SmartStack STS16-20D/STS16-20R Delivering Dedicated Bandwidth to Individual Workstations Deployment Scenarios Scenario using a Stacker Link and a Matrix Switch Setting Up CrossLinks Preparing for Installation Installation Installation Summary Package Contents Materials needed for Installation Mounting the Chassis Rack or Cabinet Mounting Mounting the Switch in a Rack or Cabinet Table-Mounting Connecting Devices to the Token Ring Ports Cabling Connecting Devices to Token Ring Ports Checking the Installation Connecting using Building Wiring Applying Power Back panel of the STS16-20D Back panel of the STS16-20R Stacker Link Module SmartStack STS-LM Front Panel Connector Description SmartStack STS-LM Connectors and LEDsConnecting the Stacker Link Cable State Description Working with a Stack Inter-box Parameters Checking the Installation Send Authentication Traps, changing the Trap table in anyMenu Parameter Using the switch console Accessing Switch ManagementSwitches can be configured in two ways Using Snmp based graphical management applications Connecting the Console Connecting a Terminal Directly to the Management PortConnecting to the Management Port Using a Modem Specification Value XON/XOFF Communication Problems Diagnostic Screen StkPort Accessing Switch Management Switch Configuration These users have full access to all configuration parameters General Guidelines Password Navigating within the Menus Main Menu Configuration Menu System Description Switch Configuration ScreenDram Installed Build Description Flash Memory Installed Configured MAC AddressBurned-in MAC Address Address Format System NameSystem Location Time of Day Stack Configuration ScreenSystem Contact Number of Boxes Module Information Screen Board ID StatusModel HW Rev Vlan Configuration SmartStack STS16-20D/STS16-20R with four VLANs Vlan Configuration Menu Brdg/Rng Vlan Configuration ScreenConfiguration → Vlan Configuration Return Add Vlan Parameter Configuration for CRF ScreenView Change Parent Vlan Bridging ModeVlan Name State Vlan Parameter Configuration for BRF Screen Bridge Number 802.1Q Vlan IDLAA Vlan MAC Address Port Vlan Port ConfigurationConfiguration → Vlan Port Configuration Type Interface MAC Address IP Configuration ScreenDefault Gateway IP Address IP State Send Ping BootP Requests and Parameters Snmp Configuration Menu Spanning Tree Protocol Ieee 802.1D Spanning Tree Protocol STP Spanning Tree for BRF Screen STP Participation Bridge Priority 100Ieee STP Uses Bridge Functional Address Bridge Hello Time in Seconds 101 Bridge Forward Delay in SecondsSpanning Tree for CRF Screen CRF & Port Spanning Tree Parameters STP Priority 102 STP Mode BRF-to-CRFSwitch Priority STP Cost Switch Forward Delay in Seconds 103 Switch Hello Time in SecondsSwitch Maximum Message Age in Seconds Port Spanning Tree Parameters Number of the port Port Spanning Tree Parameters Screen104 Priority 105 Path Cost STP ModeCurrent Spanning Tree Information Screen To view more ports in the table Port Configuration Screen 106Name Cfg Loss Threshold 107 EnabledMedia Type Cfg Loss Sampling Interval Error Low Threshold Forwarding ModeError High Threshold Error Sampling Interval 109 Media Speed Duplex ModeOperation Mode Max Explorer Rate on Input Switched Port Analyzer Menu from the Configuration Menu CrossLink110 111 CrossLink Menu 112 CrossLink Configuration Screen Setting up a CrossLink 114 Clear TableDeletes all CrossLinks Whether the specified CrossLink is active or not Current CrossLink Information Screen115 What ports are in that CrossLink Address Filtering 116 Filters and Port Security Menu Configure FiltersConfigure Port Security Mode 117 Index Configure Filters Screen118 Protocol Filters MAC Address 119 Applied PortsExit Ports Configure Port Security Mode Screen Security. Then select Configure Port Security Mode120 Numerical order of entries View Port Filters Screen121 Description 122 Port number Security ModeProtocol Filters Menu Security. Then select Protocol Filters Port Filtering Attributes Protocol Class Assignment Screen123 Protocol Class Assignment Class DSAPs Port Filtering Attributes Screen124 Block None Allow all frames in this protocol class default value 125 Set at the Port Address Table Aging menu Address Aging126 Set at the Master Address Table Aging menu 127 Address Aging MenuPort Address Table Aging Screen Then select Port Address Table Aging Aging Time min 128 PortPort to which you want to assign an aging time Demand Aging Level Master Address Table Aging Screen 129Aging Time Password Menu Password is saved across warm boots and power cycles 131 Console Configuration Menu Console/Telnet Sessions Serial Link Configuration Screen Stopping the Console Session Creating a Console Session Using a ModemSetting Value 134 Telnet Configuration Screen Box Telnet Sessions Screen136 Remote Involuntary Termination of the Telnet Session Starting the Telnet SessionStopping the Telnet Session 137 138 Displays more information Syslog Daemon Screen139 Deletes an entry 140 Change Entry Modifies an existing entryZoom Dsrr Configuration 141Restrictions 142 Primary and Traced Dsrr Port Box, Port Dsrr Group Configuration Screen143 Group View and Change Dsrr Configuration Screen144 State Group Status Group Priority Backup for Primary PortBackup for Traced Port Hello Time 146 ATM Address Download/Upload Menu BootstrapBoot 147 Serial Link Download Screen 148 149 Select Serial Link Download Select Main Image Download Download/Upload Tftp Download/Upload Screen150 Tftp Server Address 151 Execute name Download/Upload Reset Switch With Diagnostics Reset ScreenNumber of Resets Since Diagnostics Reset Switch Without Diagnostics 153 Reset Port Address Table Power-On DiagnosticsClear Nonvolatile RAM 154 Monitoring the Network from the Console Statistics Menu 155 Statistics Menu 156 Switch Statistics Screen Pending Send Requests 158 Error Frames ReceivedFrames Lost Currently Active Stations Power Supply Information Screen 159 Ins Port Status Screen160 Spd 161 Oper Mode Fwd Mode Port Statistics Menu 162 General Statistics Screen Frames Unknown 164 MAC Frames ForwardedFrames Processed Broadcast Frames Received Address Table Overflows Frame Errors165 Address Chain Overflows Receive Buffer Overflows Last Reset Config LossConfig Loss Reason 166 Ring Number Mismatch AC Errors Line ErrorsBurst Errors Statistics Screen Lost Frame Errors Abort Transmit ErrorsInternal Errors Frame Copied Errors Frequency Errors RecoveriesLobe Wires 169 Transmit Beacons Ring Status State Information Screen170 Ring State Ring Speed Next Open Uptime When Beacon171 Upstream Neighbor TXI Information DTR MAC Information Menu172 Station-CPort Information 173 Error Report TimerTXI Information Screen Authorized Function Classes Monitor State 174Join State Beacon Source Address Station-CPort Information Screen CPort Phantom Drive Mask Common Access Protocol Mask176 Common Policy Flags Address Tables Menu 177 Master Address Table Master Address Table Screen178 Address 179 Search Master Route Descriptor Table Screen180 Master Route Descriptor Table 181 Route hex Unknown Vlan Address Table Screen 182Select Vlan Address Table Vlan Route Descriptor Table Screen 183Select Vlan Route Descriptor Table Locate MAC Address Screen 184First Vlan to which the MAC address is known Bridge ID Current Spanning Tree Information Screen185 Root ID Max Message Age Forward Delay186 Hello Time PId DCst Designated Cost Dsg SwId/BrId Designated Switch Id/Bridge Id187 Dsg PId Designated Port Id Current Spanning Tree Information for a CRF Screen 188Root Port 189 Hello Time PId Port ID 190 Dsg SwId/BrId Designated Bridge ID Dsg PId Designated Port Identifier 191 Vlan StatisticsVlan Statistics Screen for CRF Parent BRF List of ports that belong to this CRF Vlan Statistics for BRF Screen192 Ports Vlan Statistics Screen for BRF appears Dsrr Status Screens Dsrr Status Tables Screen193 Neighbor Last Seen Dsrr Neighbor Table Screen194 Displays the next entry sorted by MAC Address 195 Dsrr Acting as Backup Table ScreenTime Acting as Backup Closes the screen and returns to the Dsrr Status menu Diagnostic Test Results Screen 196 197 Message ContentMessage Log Information Screen Log 198 Back Start/EndClear Pressing ESC, you cancel and return to previous menu Display Summary Screen199 200 Monitoring the Network with Snmp Snmp SetupFollowing sections describe the Snmp setup menus 201 Send Authentication Traps Snmp ConfigurationSnmp Configuration Screen Enable Rmon Statistics 203 Snmp over MAC Configuration → Community StringsCommunity Strings Screen Community Strings 204 Community NameMode Configuration → Trap Receivers Trap Receivers Screen205 List of Supported Traps from a STS16-20D/STS16-20R 206 Add EntryGeneral traps 207 Enterprise specific traps from STS16.MIBPer Port Traps 208 Traps for the Spanning Tree ProtocolTraps for CrossLinks 209 210 Active Monitoring Monitoring Port Traffic211 Passive Monitoring 212 Analyzer Port Number Switched Port Analyzer Screen213 Monitored Port Number 214 Troubleshooting in a Network TroubleshootingObtaining Service Start of Troubleshooting Process Procedure a Choosing a Troubleshooting ProcedureSymptom and LED State Go To Procedure B Procedure C Procedure D217 218 219 220 Getting in Touch with Technical Support 221 Switch Configuration Problem Report FormSwitch Information 222 Problem Description Network Installation Sketch 223 224 Appendix A. Abbreviations 225 226 Mbps 227 TrBRFTrCRF 228 Appendix B. Cable and Pin Information Connecting to the Out-of-Band Management PortCable Function Cable Type or Cable Solution Out-of-Band Management Port and Cable Pin-Outs Shell Pin Signal Name230 Management Port Pin-Out TIA/EIA-232 Modem Cable Connections TIA/EIA-232 Null-Modem Cable for 25-pin Connector 231 232 Ohm IBM STP Data Connector-to-RJ-45 Straight-Through CableTwisted-Pair Cable Pin Outs Straight-Through 100-Ohm/120-Ohm Cable Cable Type Impedance Cabling Recommendations233 Number Of Attaching Devices Ring Types Speed If using any 4 Mbps only adapters or filters234 Ring Speed Ohm Type Ohm Category 235 Ring Speed 100 or 120 Ohm CategoryMbps 350 m 1148 ft 200 m 656 ft Not Supported 90 m 295 ft 236 Index NumericsIndex-1 Index-2 194 Index-3 Index-4 191 Index-5 Index-6 Page 710001812