| 145 |
inactive | Disabled |
stop | Transient state during enable/disable |
idle | Both primary and traced port down |
groupPortDown | Primary port down |
tracedPortDown | Traced port down |
active | Operational |
stopOnError | Error condition. Check the Message Log. Then disable the |
| group, correct the error and enable the group again. |
Group Priority
Whenever more than one switch is able to take over from a failed switch, the one with the highest priority will be chosen. Possible values are
Hello Time
Interval between hello packets sent by DSRR for this group. Possible values are
Hold Time
If no hello packets are received from a switch for this group within the interval specified here, the switch will be declared failed. Possible values are
Traced Port
Identification of the (virtual ATM) port connected to the emulated (or other legacy)
Backup for Primary Port
Identifies a port for forwarding traffic that has been taken over from a failed switch. This port must be connected to the same legacy Token Ring as the port that identifies (together with Group Id) the DSRR group that is being configured. See Figure 27. on page 142.
Backup for Traced Port
Identifies a backup port for forwarding traffic that has been taken over from a failed switch. If the Traced Port is a Virtual ATM Port, the backup port must be able to join the same emulated
Switch Configuration | SmartStack |