Chapter 6 Command Definitions

6.5.25CNXCI – Configuration Cross Connect Initiate

Synopsis

This command initiates a cross connect path across the Signaling Gateway between 2 PCM timeslots; the incoming timeslot (ITS) and the outgoing timeslot (OTS). If DUPLEX is not set to Y, a simplex cross connect is initiated from ITS to OTS.

Syntax

CNXCI:OTS=,ITS=,[DUPLEX=];

Prerequisites

The PCM on which the OTS exists must have already been initiated and the OTS must be within the correct range for the PCM type (0 to 31 for E1 and 1 to 24 for T1 PCMs).

The PCM on which the ITS exists must have already been initiated and the ITS must be within the correct range for the PCM type (0 to 31 for E1 and 1 to 24 for T1 PCMs).

OTS is not already assigned elsewhere on the system for output. ITS is not already assigned elsewhere on the system for input.

Attributes

CONFIG

Examples

CNXCI:OTS=1-1-16,ITS=2-1-16,DUPLEX=Y;

6.5.26CNXCE – Configuration Cross Connect End

Synopsis

This command ends a Cross Connect connection across the converter.

Syntax

CNXCE:OTS=,[DUPLEX=,];

Prerequisites

The OTS must already be initiated as an OTS in a Cross Connect connection path.

If DUPLEX=Y is specified, a duplex connection must already exist for the specified OTS.

Attributes

CONFIG

Examples

CNXCE:OTS=1-1-16;

64

Page 64
Image 64
Dialogic SS7G2X manual Cnxci Configuration Cross Connect Initiate, Cnxce Configuration Cross Connect End