Chapter 6 Command Definitions
6.11.9RDPRC – Remote Data Centre Periodic Report Change
Synopsis
This command changes parameters relating to a report collection period for which data is collected and transferred over Ethernet to a Remote Data Centre (RDC).
Reports for outgoing route traffic measurements can be specified.
The label is used as the directory name on the RDC that the files are written to.
The period is the interval between which data is collected. It is rounded to the nearest 5 minute interval.
Data can be added or deleted from the periodic report using the RDPDI or RDPDE commands.
Syntax
RDPRC:REPORT=,[PERIOD=,][LABEL=,][RDC1=,][RDC2=,][RESET=,];
Prerequisites
•The report must already be initiated.
•If specified, RDC2 cannot have the same value as RDC1.
•If specified, RDC1 must already be initiated.
•If specified, RDC2 must already be initiated.
Limitations
Before transfer to an RDC can take place, the directory (represented by the label) must exist on the remote site.
Attributes
CONFIG
Examples
RDPRC:REPORT=1,PERIOD=01:00:00,RDC1=1,LABEL=SS7;
6.11.10RDPRE – Remote Data Centre Periodic Report End
Synopsis
This command ends a periodic report.
Syntax
RDPRE:REPORT=;
Prerequisites
•The report has already been initiated.
•There is no periodic data associated with the periodic report.
Attributes
CONFIG
Examples
RDPRE:REPORT=1;
104
