Dialogic® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.6.6C7RTC – CCS SS7 Route Change
Synopsis
This command is used to change the attributes of an SS7 Route. The DPC parameter in this command supports an extra value ‘DFLT’. When a route is specified as default, messages destined for DPCs within the network context that have not been configured by the system is sent to the default route.
Syntax
C7RTC:C7RT=,NC=,[DPC=,][LS1=,][LS2=,][LSH=,][LABEL=,];
Prerequisites
•
•
•
•
•
•
If specified, LS2 must have same SS7MD, NI, NC, and OPC as LS1. If specified, LS1 must have same SS7MD, NI, NC, and OPC as LS2. The specified route has already been initiated.
Any link set specified has already been initiated.
The DPC/NC combination (associated with the route’s link sets) must be different for each route.
If changing any parameter other than the LABEL, all SS7 signaling links must be blocked.
Note: After blocking, an SS7 link cannot be unblocked until all the boards processing the SS7 signaling are blocked and then unblocked.
•
•
Only one default route can be configured per network context.
If a default route is specified, a network context cannot be configured with a DPC of 0.
Attributes
CONFIG
Examples
C7RTC:C7RT=1,NC=1,LS1=2;
71
