Dialogic® SS7G2x Signaling Server SGW Mode User Manual Issue 4
6.13.11SNSLC – SIGTRAN Signaling Link Change
Synopsis
This command changes parameters on a SIGTRAN link. A SIGTRAN link provides an SCTP association to an adjacent SIGTRAN server.
If two IP addresses are specified, the first IP address is used until it proves unreliable in which case the second is used.
An IP address of 0.0.0.0 indicates that the parameter is not configured.
When SECURE is set to Y, the SIGTRAN link does not come into service on unblocking if it receives messaging from a peer that has an IP address not associated with the SIGTRAN link.
Note: Normal operation for M2PA would be to set both ends to client.
Syntax
SNSLC:SNLINK=,END=,[IPADDR=,][IPADDR2=,][HPORT=] [PPORT=,][SRTX=,][LABEL=,][SECURE=,];
Prerequisites
•
•
The SIGTRAN link has already been initiated and is blocked. The END can only be Client (C) or Server (S).
Attributes
CONFIG
Examples
SNSLC:SNLINK=1, PPORT=2905;
6.13.12SNSLE – SIGTRAN Signaling Link End
Synopsis
This command ends the configuration of parameters on a SIGTRAN signaling link.
Syntax
SNSLE:SNLINK=;
Prerequisites
•
•
•
•
The SIGTRAN link has already been initiated and is blocked.
The SIGTRAN link cannot be ended if it is attached to an Application Server (AS). There cannot be any NC/NA mapping configured on the SNLINK.
The SNLINK cannot be ended if it is associated with a C7LINK.
Attributes
CONFIG
Examples
SNSLE:SNLINK=1;
121
