EPSON AcuLaser C1100 Revision B

TROUBLESHOOTING FIP according to the printer message 159

FIP-26

Panel Message
Jam LC, G
Possible parts that caused the error
Troubleshooting

ROLL ASSY TURN 500 ROLL ASSY FEED 500

HOLDER ASSY RETARD 500 SOLENOID FEED

HARNESS ASSY MAIN DRIVE ASSY FEED

PWBA TRAY 500 HARNESS-ASSY FEED 1

ACTUATOR T/R SENSOR T/R

HARNESS ASSY FEED 3 PWBA MCU

LV/HVPS CLUTCH ASSY FEED

HARNESS-ASSY FEED MAIN DRIVE ASSY FEED

Step Check Yes No
1Check of the paper
Is the paper loaded in the paper tray wrinkled
or torn?
Replace with
new, dry paper. Go to Step [2].
2Paper size setting check
Does the size of the paper in use match the
size of the paper set on the control panel?
Go to Step [4]. Change the
paper size
setting, and
proceed to step
[3].
3Does the error recur when a test print is
made? Go to Step [4]. End of
procedure
4Shape and operation check of ROLL ASSY
of Feeder section
Open COVER-REAR 500 of Feeder.
Are ROLL ASSY TURN 500, HOLDER
ASSY RETARD 500, ROLL ASSY FEED
500 and other parts attached correctly?
Also, do these parts rotate smoothly without
any dirt or damage?
Turn by hand to check.
Go to Step [5]. Replace the
ROLL in
question.
5Does the error recur when a test print is
made? Go to Step [6]. End of
procedure
6Operation check of SOLENOID FEED
Does SOLENOID FEED operate correctly?
Make a test print and confirm.
Go to Step [12]. Go to Step [7].
7Continuity check of HARNESS-ASSY
FEED MAIN
Disconnect P/J437 from PWBA TRAY 500.
Do all of the wiring below have normal
continuity?
J437-16 ↔ P610-2
J437-17 ↔ P610-1
Go to Step [8]. Replace
HARNESS-
ASSY FEED
MAIN.
8Check after replacement of DRIVE ASSY
FEED
Replace DRIVE ASSY FEED 250. (p.458)
Does the error recur when a test print is made?
Go to Step [9]. End of
procedure
9
Check after replacement of PWBA TRAY 500
Replace PWBA TRAY 500. (p.456)
Does the error recur when a test print is made?
Go to Step [10]. End of
procedure
10
Continuity check of HARNESS-ASSY FEED 1
Disconnect P/J435 from PWBA TRAY CONT.
Do all of the wiring below have normal
continuity?
J435-2 ↔ P608-9
J435-3 ↔ P608-8
J435-4 ↔ P608-7
Go to Step [11]. Replace
HARNESS-
ASSY FEED 1.
(p.462)
Step Check Yes No