Parent topic: Solving Problems

Product Status Messages

You can often diagnose problems with your product by checking the messages on its LCD screen.

Note: If the screen is dark, press the screen to wake the product from sleep mode.

LCD screen message

Condition/solution

Printer error. Turn the power off and

A serious error has occurred. Turn the product off and then back

on again. If the error is not fixed,

on again. If the error continues, check for a paper jam. If there is

contact Epson Support.

no paper jam, contact Epson for support.

A printer's ink pad is nearing the end

The ink pads are near the end of their service life and the

of its service life. Please contact

message will be displayed until the ink pad is replaced. Contact

Epson Support.

Epson to replace ink pads before the end of their service life. (To

 

resume printing, press one of the buttons.)

A printer's ink pad is at the end of its

The ink pad is at the end of its service life. Turn off the product

service life. Please contact Epson

and contact Epson for support.

Support.

 

No dial tone detected. Try the Check

Make sure the phone cable is connected correctly and the

Fax Connection.

phone line works. If you connected the product to a PBX (Private

 

Branch Exchange) phone line or Terminal Adapter, turn off the

 

Dial Tone Detection setting.

Combination of IP address and

There is a problem with the network connection to your product.

subnet mask is invalid. See your

 

documentation.

 

Communication error

There is a problem with the network connection to your product.

 

Check the DNS settings for the server, the computer, or the

 

access point.

Recovery mode

An error has occurred during firmware updating. Connect your

 

product using a USB cable and try downloading the Firmware

 

Update from Epson's support website. If you still need help,

 

contact Epson for support.

Parent topic: Solving Problems

 

239

Page 239
Image 239
Epson WF2660 manual Product Status Messages, LCD screen message Condition/solution, Dial Tone Detection setting