Hardware Exercises
3.When the test is finished, the screen displays Status Complete and you can press >(VFDSH@ to return to the Diagnostics Menu.
Note: If you want to stop a test in progress, press >(VFDSH@, then
>(QWHU@.
The following table describes each test and also provides additional instructions for performing the tests (if applicable).
Diagnostic | Description | Additional instructions |
test |
|
|
|
|
|
Self Test | Causes the CHM to cycle the |
|
| gripper fingers, the short axis, |
|
| the long axis, and the |
|
| entry/exit port. The drum |
|
| assembly rotates and the |
|
| CHM moves to its home |
|
| position. |
|
|
|
|
Position to | Moves the CHM to a tape | When you select Position to Elem, the Set |
Elem | drive, cartridge slot, or the | Destination screen appears. Press >@ or |
| entry/exit port. | >@ to select the element index where you |
|
| want to position the CHM. Then press |
|
| >(QWHU@. |
|
|
|
Park | Moves the CHM to the park |
|
| position at the bottom of the |
|
| long axis. |
|
|
|
|
Move | Moves a cartridge from one | When you select Move Cartridge, the Set |
Cartridge | location to another. | Source screen appears. Press >@ or >@ to |
| Important: Do not insert a | select the source index (the slot you want |
| cartridge in a tape drive. The | the CHM to pick from), then press >(QWHU@. |
| The Set Destination screen appears. | |
| tape drive will not eject the | |
| Press >@ or >@ to select the destination | |
| cartridge. | |
| index (the slot where you want the CHM | |
|
| |
|
| to place the cartridge). Then press >(QWHU@. |
|
|
|
Installation and Operation | 121 |
