Library Operation
Replacing a single cartridge
As described in this section, you can use several different methods to replace single cartridges without opening the library door.
Use the Extend/Retract E/E option to insert or remove cartridges through the entry/exit port.
Use the Remove Cartridge option to remove the cartridge.
Use the Insert Cartridge option to replace the cartridge.
➤Important Do not open the library door to replace individual cartridges. Opening and closing the library door causes the library to update the cartridge inventory, which takes approximately 2½ to 5 minutes.
Using the Extend/ Retract E/ E option
1.Make sure that security is disabled (see page 60).
2.From the Main Menu, select Extend/Retract E/E. The library extends or retracts the entry/exit port transport arm, depending on its current position.
3.Insert the cartridge into the entry/exit port and press >(QWHU@; or, remove a cartridge by pressing down on the entry/exit port PUSH tab, as shown in the following figures.
Installation and Operation | 73 |
