Exabyte 440, 480 manual Connect the power cord, Power on the library

Hardware Installation

Step 9 – Connect the power cord

➤Important The power cord shipped with the library is a 120 VAC three-conductor power cord for use in the United States or Canada. If you are planning to use another input voltage or if you plan to use the library outside of the U.S. or Canada, you must supply your own power cord. For more information, refer to Appendix A.

1.Make sure that the power switch on the back of the library is off (the 0 is pressed).

2.Connect the female end of the power cord to the power connector on the back of the library.

3.Plug the male end of the power cord into the power source.

Note: The library has autoranging voltage selection, so you do not need to change the voltage setting.

Step 10 – Power on the library

1.Make sure the library’s door is closed and locked.

2.Power on the host computer.

Note: If your host requires that attached peripheral devices be powered on before the host, power on the library before powering on the host.

3.Push the power switch on the back of the library to the on (I) position.

Installation and Operation 43