Fortinet 3.0 MR4 System ha remote-as-heartbeat, Set system ha remote-as-heartbeat enable disable

system ha remote-as-heartbeat set

system ha remote-as-heartbeat

Use this command to enable or disable using remote monitoring as an HA heartbeat. Enable using remote monitoring as an HA heartbeat so that if both the primary and secondary heartbeat links fail, remote service monitoring takes over the role of the HA heartbeat. This means that if remote service monitoring is enabled and both heartbeat links fail or become disconnected, the FortiMail HA group can continue to operate.

Using remote services as heartbeat provides HA heartbeat only. HA synchronization is only supported using the primary or secondary heartbeat. To avoid synchronization problems, you should not use remote service monitoring as a heartbeat for extended periods. This feature is intended only as a temporary heartbeat solution that operates until you reestablish a normal primary or secondary heartbeat link.

Syntax

set system ha remote-as-heartbeat {enable disable}

Example

Enter the following command to enable using remote monitoring as an HA heartbeat::

set system ha remote-as-heartbeat enable

History

FortiMail v3.0 MR2 New.

Related topics

•set system ha config

•set system ha {cpeer interface peer secondary-interface secondary-peer}

•set system ha data

•set system ha datadir

•set system ha lservice

•set system ha mode

•set system ha monitor

•set system ha on-failure

•set system ha passwd

•set system ha {restart restore resync}

•set system ha rservice

•set system ha takeover

	FortiMail™ Secure Messaging Platform Version 3.0 MR4 CLI Reference
326	06-30004-0420-20080814