HP 300X manual DLC/LLC Configuration Messages, General HP JetDirect Messages 1

Table 7.4 DLC/LLC Configuration Messages

Message	Description
DLC/LLC STATUS:	Current DLC/LLC status:
	DISABLED: Indicates that DLC/LLC was manually disabled
	through the printer's control panel (if available).
	DISABLED: Indicates that LAN Server was manually
	disabled through the printer's control panel (if available).
	READY: Indicates the HP JetDirect print server is awaiting
	data.
	NOT IN USE: Code is in the middle of a download.
SERVER ADDRESS:	Station address of the remote end of the connection.

Table 7.5	General HP JetDirect Messages (1 of 15)
Message		Description
ARP DUPLICATE IP		The ARP layer has detected another node on the network
ADDRESS		using the same IP address as the HP JetDirect print server.
		Extended error information below this message shows the
		hardware address of the other node.
AUTONEGOTIATION		Identifies whether IEEE 802.3 Autonegotiation on the
ON		HP JetDirect 10/100TX port is enabled (ON) or disabled
OFF		(OFF). If ON, the HP JetDirect print server will attempt to
		automatically configure itself onto the network at the proper
		speed (10 or 100 Mbps) and mode (half or full duplex). If
		OFF, you must manually configure the speed and mode
		using switches or jumpers on the print server.
AUTO-REMOVAL		The HP JetDirect print server detected an internal hardware
ERROR		error following the Token Ring beacon auto-removal process
		and has removed itself from the ring.
BABBLE ERROR		Run the power-on self-test: turn the printer off, then on
		again. If the error persists, replace the HP JetDirect print
		server. For information on replacing your HP JetDirect print
		server, see the hardware installation guide for your print
		server.
BAD BOOTP REPLY		An error was detected in the BOOTP reply that the
		HP JetDirect print server received. The BOOTP reply either
		had insufficient data in the UDP datagram to contain the
		minimum BOOTP header of 236 bytes, had an operation
		field that was not BOOTPREPLY(0X02), had a header field
		that did not match the print servers hardware address, or
		had a UDP source port that was not the BOOTP server port
		(67/udp).

EN HP JetDirect Configuration Page Messages 115