HP 300X manual General HP JetDirect Messages 10

Table 7.5	General HP JetDirect Messages (10 of 15)
Message		Description
PARALLEL		CENTRONICS indicates a standard parallel connection that
PORT X:		transfers data in one direction only (to the printer).
		BIDIRECTIONAL indicates a parallel connection that
		supports bidirectional communications.
		BITRONICS indicates a parallel connection that supports
		bidirectional communications.
		ECP_MLC or ECP_MLC2 indicates a bidirectional parallel
		connection (IEEE-1284) that supports an enhanced
		capabilities port.
		DISCONNECTED indicates that no printer is attached to the
		port or the printer is not turned on.
PASSWORD ERROR		The HP JetDirect print server detected that the password
		for the NetWare print server object is wrong. Use the
		PCONSOLE utility to erase the password for the print server
		object. When the HP JetDirect print server logs on again, it
		sets a new password.
		Note: When multiple file servers are configured, the error is
		only displayed on the configuration page if none of the file
		servers are connected.
PORT CONFIG		Indicates whether the RJ-45 port on the HP JetDirect print
		server is configured for network communications using a
		10/100Base-TX full- or half-duplex channel. For MIO cards,
		a “-M” suffix indicates the configuration has been manually
		set using switches or jumpers.
PORT SELECT:		Specifies the port on the print server that has been detected
		for use: RJ-45, BNC (10Base2), or DB9.
		If DISCONNECTED is displayed, verify that the network
		cable has been properly attached to the desired port.
POSTSCRIPT MODE		The printer does not support the EtherTalk MIO extensions.
NOT SELECTED		It may be a printer which does not support AppleTalk. When
or POSTSCRIPT		this message is displayed, the other AppleTalk messages
UPDATE NEEDED		(ADDRESS, APPLETALK NAME, ZONE NAME) are not
		displayed.
PRINT SERVER NOT		The file server does not have a print server object that
DEFINED		corresponds to the specified NetWare node name. Use
		printer installation software or PCONSOLE to create the
		print server object.
		When the HP JetDirect print server is configured for multiple
		file servers, the error is only displayed on the configuration
		page if none of the file servers made the connection.

124 HP JetDirect Configuration Page Messages

EN