Table 7.5 | General HP JetDirect Messages (14 of 15) | |
|
|
|
Message |
| Description |
|
| |
UNABLE TO GET NDS | The NDS server address cannot be located or accessed. | |
SRVR ADDR |
|
|
|
| |
UNABLE TO LOGIN | A failure was detected when the HP JetDirect print server | |
|
| tried to log onto the file server. This could be caused by the |
|
| print server object not existing on the file server, or because |
|
| of a security check that prevents the print server from |
|
| logging in. |
|
| Make sure the file server name and print server object name |
|
| are correct. Use PCONSOLE to erase the password for the |
|
| print server object. Create a new print server object. |
|
| When the HP JetDirect print server is configured for multiple |
|
| file servers, the error is only displayed on the configuration |
|
| page if none of the file servers made the connection. |
|
| |
UNABLE TO SENSE | The HP JetDirect print server has been trying for over 3 | |
NET NUMBER | minutes to determine the NetWare protocol used on the | |
|
| network. Make sure that any file servers and routers are |
|
| operating correctly. Make sure that the settings for NetWare |
|
| frame type and source routing are correct. |
|
| |
UNABLE TO SET | A failure was detected when the HP JetDirect print server | |
PASSWORD |
| tried to set the password for the print server object. |
|
| (Whenever the HP JetDirect print server is able to log in |
|
| without a password, it sets the password automatically.) This |
|
| indicates a networking or security problem. Create a new |
|
| print server object. |
|
| When multiple file servers are configured, the error is only |
|
| displayed on the configuration page if none of the file servers |
|
| were successfully connected. |
|
| |
UNDERFLOW ERROR | Check the cabling and BNC “T” connectors. If the error | |
|
| persists, run the |
|
| on again. If the error persists, replace the HP JetDirect print |
|
| server. For replacement instructions, see the hardware |
|
| installation guide for your print server. |
|
| |
UNEXPECTED | The print server sent some data when the HP JetDirect print | |
PSERVER DATA RCVD | server had not given its permission to do so. This indicates | |
|
| a possible print server problem, possibly a software |
|
| problem. |
|
| |
UNICAST PACKETS | Number of frames specifically addressed to this | |
RCVD: |
| HP JetDirect print server. This does not include broadcasts |
|
| or multicasts. |
|
|
|
128 HP JetDirect Configuration Page Messages
EN
