Using Telnet to Erase the Existing IP Address

To erase the IP address during a Telnet session:

1.Type cold-reset, then press [Enter].

2.Type quit, then press [Enter] to exit Telnet.

Note

This procedure resets all TCP/IP parameters, but

 

only affects the TCP/IP subsystem. After this has

 

been done the print server should be power cycled.

 

Parameters for other subsystems such as IPX/SPX

 

(Novell NetWare) or AppleTalk are not affected.

 

 

Using the Embedded Web Server

You can set IP parameters on HP JetDirect print servers that support the embedded web server. For more information, refer to Appendix B.

EN

TCP/IP Configuration 51

Page 57
Image 57
HP 300X manual Using the Embedded Web Server, Using Telnet to Erase the Existing IP Address