HP 300X manual General HP JetDirect Messages 2

Table 7.5 General HP JetDirect Messages (2 of 15)

Message	Description
BAD BOOTP TAG SIZE	The tagsize in a vendor specific field in the BOOTP reply is
	either 0, or greater than the remaining number of
	unprocessed bytes in the vendor specified area.
BAD LENGTH RCVD:	Total number of frames missed because they were too long
	for the HP JetDirect print server to receive.
BAD PACKETS RCVD:	Total number of frames (packets) received by the
	HP JetDirect print server with errors.
BOOTP/DHCP IN	The HP JetDirect print server is currently in the process of
PROGRESS	obtaining its basic IP configuration information through
	BOOTP/DHCP, and has not detected any errors.
BURST ERRORS	Number of times the HP JetDirect Token Ring print server
RCVD:	could detect no transitions for 5 half-bit times between the
	Start Delimiter (SD) and the End Delimiter (ED).
CF ERR - ACCESS	The TFTP configuration file specified too many access list
LIST EXCEEDED	entries using the “allow:” keyword.
CF ERR - FILE	The TFTP configuration file contained an incomplete last
INCOMPLETE	line that did not end in a newline character.
CF ERR - INVALID	A line in the TFTP configuration file contained an invalid
PARAM	value for one of the parameters on that line.
CF ERR - LINE TOO	A line being processed in the TFTP configuration file was
LONG	longer than the HP JetDirect print server could accept.
CF ERR - MISSING	A line in the TFTP configuration file was missing a required
PARAM	parameter.
CF ERR - TRAP LIST	The TFTP configuration file specified too many trap
EXCEEDED	destination list entries using the “trap-destination:” keyword.
CF ERR - UNKNOWN	A TFTP configuration file line contained an unknown
KEYWORD	keyword.
CONFIGURATION	The configuration information for the NetWare functions is
ERROR	not stored correctly on the HP JetDirect print server. Rerun
	the installation software to reconfigure. If this error persists,
	there may be a problem with the HP JetDirect print server.
CRC ERROR	Check the network topology and verify all cable segments.
	Check for damaged cables.

116 HP JetDirect Configuration Page Messages

EN