![](/images/new-backgrounds/1284716/284716261x1.webp)
Table 7.5 | General HP JetDirect Messages (11 of 15) | |
|
|
|
Message |
| Description |
|
| |
PRINTER NUMBER IN | The printer number assigned to the printer is already in use | |
USE |
| by another printer. Assign an unused printer number. This |
|
| may also occur when a printer is power cycled, in which case |
|
| the error goes away after the print server times out and |
|
| detects the lost connection. |
|
| |
PRINTER NUMBER | The printer number you assigned to the remote printer has | |
NOT DEFINED | not been defined. Assign a valid printer number to the | |
|
| HP JetDirect print server, or run PCONSOLE and define a |
|
| printer number for the print server. |
|
| |
PSERVER CLOSED | The print server requested a termination of the connection | |
CONNECTION | with the HP JetDirect print server. No error exists or is | |
|
| indicated. Make sure the print server is running, and restart |
|
| it if necessary. |
|
|
|
READY |
| The HP JetDirect print server has successfully connected |
|
| to the server and is awaiting data. |
|
| |
RECEIVE BUFFER | Run the | |
ERROR |
| again. If the error persists, replace the HP JetDirect print |
|
| server. For replacement instructions, see the hardware |
|
| installation guide for your print server. |
|
| |
REMOVE RECEIVED | The HP JetDirect print server has received a Remove | |
|
| Adapter data frame during the Token Ring insertion process, |
|
| or has received a remove ring station data frame request, |
|
| and has removed itself from the ring. |
|
| |
REQUEST PARAM | The HP JetDirect print server determines that a Ring | |
|
| Parameter Server (RPS) is present on the ring, but does not |
|
| respond to a request initialization data frame. |
|
| |
RETRY ERROR | Verify that the Ethernet network cable is correctly terminated | |
|
| on both ends. Make sure your HP JetDirect print server is |
|
| correctly attached to your network. |
|
| |
RING BEACONING | The HP JetDirect print server receives a beacon data frame | |
|
| after physically inserting into the ring. This indicates a break |
|
| in the ring. |
|
| |
RING FAILURE | The HP JetDirect print server times out when attempting a | |
|
| ring purge after becoming the active monitor; that is, the |
|
| HP JetDirect print server is unable to receive its own ring |
|
| purge data frames. |
|
| |
RING RECOVERY | The HP JetDirect print server has received claim token data | |
|
| frames on the ring. The HP JetDirect print server may be |
|
| transmitting the claim token frames. |
|
|
|
SECURITY |
| The security equivalences for your print server are not set |
EQUIVALENCE NOT | up properly. Reconfigure your print server. | |
SET |
|
|
|
|
|
EN | HP JetDirect Configuration Page Messages 125 |