Table 7.5 General HP JetDirect Messages (4 of 15)
Message | Description |
|
|
FIRMWARE | The firmware revision number of the HP JetDirect print |
REVISION: X.XX.XX | server currently installed in the printer. |
|
|
FRAME COPIED | Total number of Token Ring frames received with the frame |
RCVD: | copy error indicated in the Frame Status (FS) field. |
|
|
FRAMING ERROR | Check the network topology and verify all cable segments. |
| Check for damaged cables. |
|
|
FRAMING ERRORS | Maximum of CRC (Cyclic Redundancy Check) errors and |
RCVD: | framing errors. CRC errors are frames received with CRC |
| errors. Framing errors are frames received with alignment |
| errors. A large number of framing errors could indicate a |
| cabling problem with your network. |
|
|
FS SET ERRORS | Total number of Token Ring frames with frame status set |
RCVD: | errors, indicating another node could not set the frame |
| status. |
|
|
FUNCTION FAILURE | The HP JetDirect print server is unable to transmit to itself |
| while wrapped through its lobe at the Token Ring wiring |
| concentrator. This message may also indicate that data |
| frames were received before physical insertion. |
|
|
HARD ERROR | The HP JetDirect print server is transmitting or receiving |
| beacon frames to or from the ring. |
|
|
HP JETDIRECT | Identifies the HP JetDirect print server model number. |
JXXXXX |
|
|
|
INITIALIZING TRYING | The HP JetDirect print server is trying to connect to the |
TO CONNECT TO | NetWare server(s). This is a normal message. Wait until the |
SERVER | connection is established or another status message |
| appears. |
|
|
INVALID GATEWAY | The default gateway IP address specified for the |
ADDRESS | HP JetDirect print server (through BOOTP or NOVRAM) is |
| an invalid IP address for specifying a single node. |
|
|
INVALID IP ADDRESS | The IP address specified for the HP JetDirect print server |
| (through BOOTP or NOVRAM) is an invalid IP address for |
| specifying a single node. |
|
|
INVALID SERVER | The TFTP server IP address specified for the HP JetDirect |
ADDRESS | print server (through BOOTP) is an invalid IP address for |
| specifying a single node. |
|
|
INVALID SUBNET | The IP subnet mask specified for the HP JetDirect print |
MASK | server (through BOOTP or NOVRAM) is an invalid subnet |
| mask. |
|
|
INVALID SYSLOG | The syslog server IP address specified for the HP JetDirect |
ADDRESS | print server (through BOOTP) is an invalid IP address for |
| specifying a single node. |
|
|
118 HP JetDirect Configuration Page Messages
EN
