![](/images/new-backgrounds/1284716/284716253x1.webp)
Table 7.5 | General HP JetDirect Messages (7 of 15) | |
|
|
|
Message |
| Description |
|
|
|
LAN |
| There may be a problem with your network cabling or the |
HP JetDirect print server. Check the cabling and BNC “T” | ||
R OFF |
| connectors on your Ethernet network. If you cannot find a |
|
| problem with your network cabling, run the |
|
| |
|
| persists, there is a problem with the HP JetDirect print |
|
| server. |
|
|
|
LAN |
| There may be a problem with your network cabling or the |
| HP JetDirect print server. Check the cabling and BNC “T” | |
|
| connectors on your network. If you cannot find a problem |
|
| with your network cabling, run the |
|
| the printer off, then on again. If the error persists, there is a |
|
| problem with the HP JetDirect print server. |
|
| |
LAN | There is a problem with the network cabling. Check the | |
FAULT |
| cabling between the printer and the network. |
|
| |
LAN HW ADDRESS: | The | |
XXXXXXXXXXXX | HP JetDirect print server installed in the printer. | |
|
| |
LATE COLLISION | Check the network topology, verify all cable segments, and | |
ERROR |
| make sure no segment is too long. |
|
| |
LINE ERRORS RCVD: | Total number of Token Ring frames received by the | |
|
| HP JetDirect print server with code violations or CRC |
|
| (Cyclic Redundancy Check) errors. A large number may |
|
| indicate faulty cabling on your network. |
|
| |
LOBE WIRE FAULT | The HP JetDirect print server has detected an open or short | |
|
| circuit in the cable between the HP JetDirect print server |
|
| and the Token Ring wiring concentrator. Verify that this cable |
|
| is functional and replace it if necessary. |
|
| |
LOSS OF CARRIER | Check the network connections. If the connections are | |
ERROR |
| intact, run the |
|
| on again. If the error persists, replace the HP JetDirect print |
|
| server. For replacement instructions, see the hardware |
|
| installation guide for your print server. |
|
| |
LOST FRAMES: | Number of times the end of the frame could not be detected | |
|
| while transmitting. |
|
| |
MEMORY ERROR | Run the | |
|
| again. If the error persists, replace the HP JetDirect print |
|
| server. For replacement instructions, see the hardware |
|
| installation guide for your print server. |
|
|
|
MFG ID: |
| The manufacturing identification code. |
|
|
|
NDS |
| Unable to log onto the NetWare directory tree. Make sure |
AUTHENTICATION | that the print server object is defined in the directory at the | |
ERROR |
| correct context. |
|
|
|
EN | HP JetDirect Configuration Page Messages 121 |