HP 300X manual Telnet Configuration Parameter Examples 1

Table 3.3 Telnet Configuration Parameter Examples (1 of 2)

IP Address	ip:	where ip identifies the parameter
Parameter	13.32.11.24	and 13.32.11.24 specifies the
Example		address for the printer. By typing
		this parameter, you can overwrite
		the IP address used to make the
		Telnet connection with one you
		have selected.
Subnet Mask	subnet-mask:	where subnet-maskidentifies the
Example	255.255.255.0	parameter and 255.255.255.0
		specifies the subnet mask.
Default Gateway	default-gw:	where default-gwidentifies the
Example	13.32.11.85	parameter and 13.32.11.85
		specifies the IP address of the
		gateway.
		Note: If the HP JetDirect print
		server is configured by DHCP and
		you change the subnet mask or the
		default gateway address (using
		front-panel, Telnet, or other tool),
		you should change the IP address
		to release the present IP address
		back to the DHCP server IP
		address pool.
Syslog Server	syslog-server:	where syslog-serveridentifies
Example	13.32.11.85	the parameter and 13.32.11.85
		specifies the IP address of that
		server.
Protocol	IPX/SPX: 1	(1 enables, 0 disables)
Enabling/Disabling	dlc-llc: 1	(1 enables, 0 disables)
Example	ethertalk: 1	(1 enables, 0 disables)
Idle Timeout	idle-timeout:	where idle-timeoutidentifies
Parameter	120	the parameter and 120 specifies
Example		the number of seconds an idle print
		data connection is allowed to
		remain open. If you set this
		parameter to 0, the connection
		does not terminate and no other
		host is able to make a connection.
Banner Page	banner: 1	(1 enables, 0 disables)
Parameter
Example

EN TCP/IP Configuration 49