![](/images/new-backgrounds/1284716/284716245x1.webp)
Table 7.5 | General HP JetDirect Messages (3 of 15) | |
|
|
|
Message |
| Description |
|
|
|
DATA RATE: |
| The Token Ring data rate at which the HP JetDirect print |
4 Mbps |
| server can transfer information. This setting should be either |
16 Mbps |
| 4 or 16 Megabits per second (4 or 16 Mbps), depending on |
JUMPER ERROR | your network configuration. If the DATA RATE field displays | |
|
| JUMPER ERROR (older HP JetDirect print servers), check |
|
| the jumper switch setting on the HP JetDirect print server. |
|
| For information on setting the jumper switch on the print |
|
| server, see the hardware installation guide for your print |
|
| server. |
|
|
|
DATE |
| Identifies the date of manufacture of the HP JetDirect print |
MANUFACTURED | server. | |
|
|
|
DHCP NACK |
| After several attempts, the DHCP server has failed to |
|
| acknowledge the configuration. The JetDirect print server |
|
| will restart the configuration process. |
|
| |
DISCONNECTED | The Novell NetWare protocol is disconnected. Check the | |
|
| server and the print server. |
|
| |
DISCONNECTING | The server has been shut down because of a configuration | |
FROM SERVER | change or reset request. This message automatically clears | |
|
| after a few seconds, unless the printer is offline, is in an error |
|
| state, or is servicing another I/O port or another network |
|
| protocol. |
|
| |
DISCONNECTING - | The SPX connection to the print server was lost after the | |
SPX TIMEOUT | connection had been made. This indicates a possible | |
|
| network problem, or a problem with the print server. Make |
|
| sure all cables and routers are functioning correctly. Try |
|
| restarting the print server. |
|
| |
DUP NODE ADDRESS | The HP JetDirect print server found another station on the | |
|
| ring that already has the address which the HP JetDirect |
|
| print server wishes to use. Make sure that all addresses are |
|
| unique. |
|
| |
ERR NEGOTIATING | A failure was detected when selecting the buffer size to be | |
BUFFER SIZE | used when reading print data from the file server. This may | |
|
| indicate a network problem. |
|
| When the HP JetDirect print server is configured for multiple |
|
| file servers, the error is only displayed on the configuration |
|
| page if none of the file servers was successfully connected. |
|
| |
FAIL RESERVING | The SPX connection to the print server was lost when the | |
PRINTER NUM | HP JetDirect print server attempted to reserve the printer | |
|
| number. This indicates a possible network problem, or a |
|
| problem with the print server. Make sure all cables and |
|
| routers are functioning correctly. Try restarting the print |
|
| server. |
|
|
|
EN | HP JetDirect Configuration Page Messages 117 |