3.Connect the other end of the cable to the Micro-USB connector port on your HP iPAQ. The cable connector only fits one way. If the connector does not insert easily, turn it over.

TIP: Charge the battery by connecting your HP iPAQ to a USB port on your computer through the Micro-USB synchronization cable. The Microsoft® ActiveSync® or WMDC program appears on the screen if you connect your HP iPAQ to a computer that has the software already installed on the computer.

To enable USB charging on your HP iPAQ, tap Start > Settings > System > Power > USB Charging. On the Power screen, select the Use USB Charging check box, select the Fast Charging option, and then tap ok.

Step 4: Turn on your HP iPAQ

Press and hold the (End/Power) key for five seconds to turn on your HP iPAQ. Follow the instructions on the screen to complete the setup. Tap the keyboard icon on the screen to use the on-screen keyboard. Alternatively, you can use the keyboard to specify information. To learn more about keyboard use, see Step 6: Use the keyboard on page 11.

NOTE: The HP iPAQ will take a few minutes to become fully functional. The keyboard will not be active during this period.

Step 5: Locate the stylus

You can use the stylus to tap and enter text using the on-screen keyboard. You can also use the stylus to tap and select items on the screen.

To remove the stylus:

1.Locate the stylus on the back of your HP iPAQ.

10 Chapter 4 Set up your HP iPAQ

Page 22
Image 22
HP Data Messenger manual Turn on your HP iPAQ, Locate the stylus