Observe the media as the fan speed changes. If the media is lifting off the platen, increase the fan speed. If the media advance seems impeded by the vacuum, decrease the fan speed.
After you save your changes by pressing the ! (Pro- ceed) key, the Leading Edge Static Control screen appears. This feature reduces overspray in areas of fine text in the first 0.6 inches (15 mm) leading edge of a rigid media print. Disable if the media is not being held suffi- cently onto the platen.
•Printing Delay — press the , and ) keys on the con- trol panel to increase or decrease the delay (seconds per print swath). To increase throughput, decrease the delay.
•Media Edge Holders — if Yes, you will be prompted dur- ing the media load sequence whether you are using the media edge holders for rollfed media. If No, you will not be prompted.
•Media Out Sensor — the sensor is used to detect the trailing edge of
•Measure Media Width — select Automatically to mea- sure the media with the digital imaging sensor (camera), or Manually to position the printhead carraige at the right and left edges of the media, or when loading transparent media, the edges of which cannot be detected by the printer.
4.Press ! (Proceed) to load the media, or press ( (Cancel) to discard your changes.
•To load media, go to “Load and Print on Rigid Media” on page
Configure Media |
