HP H35000, H45000 manual Latch Pinch roller assemblies

10.Slide the adjustable media fence against the right side of the media. Then lock it in place.

At this point you can also adjust the speed of the vacuum fans, or switch them on or off. If the sheet is warped or not being held down, increase the vacuum fans or raise the pinch rollers.

11.If the edge of the media you are using is directly below a pinch roller, raise that pinch roller by pushing it up and then pushing the latch toward the rail to engage it (see Fig. 2-5 below). To lower the pinch roller, push it up and the latch will disengage, then lower the roller to the platen.

Latch

Pinch roller assemblies Media thickness sensor

Fig. 2-5. Pinch rollers

12.Move the media edge holders (for roll-fed media) out of the media path, and make sure that the output door is closed.

13.Press the ! (Proceed) key on the control panel, or the Load/Unload switch on the back of the printer to the Load position, or the optional foot switch (if installed). This causes the printer to:

•Measure the media thickness

•Measure the media width

•Find the leading edge of the media

2-12 Load and Print on Rigid Media