Calibrating the Moveable Fence
The moveable fence is calibrated at the factory to be parallel to the top surface of the media, at a height just above the top of the table rollers (lower than the thickest media that will be used on the printer).
If the moveable fence needs to be recalibrated, follow this procedure:
1.Place a piece of rigid media under the pinch rollers, and align it against the stationary fence.
2.Slide the moveable fence next to the edge of the media and observe its position relative to the top surface of the media.
3.If the fence is not parallel to the top edge of the media, use a 2.5 mm hex wrench to turn the position screw (shown below) until the moveable arm is parallel with the media.
Fig.
Printing Tips |