HP H45000, H35000 manual Margin Settings

MEDIA WIZARD	•	Printing Delay — slows throughput (media advance speed)
		to allow the media to cool between passes, preventing warp-
		ing of rigid media or curling of roll-fed media.
	• Gutter Settings — determines the appearance of the top
		and side gutters:
		• Top Gutters — allows you to turn On or Off the gutter
			data at the top edge of the print, which shows the job
			name, ink, media, date and time printed, print mode,
			lamps setting, printer, embedded software version, Fine
			Text and Sharp Edge usage, plus write-in blanks for other
			data.
		• Side Gutters — sets the side gutter pattern to Narrow,
			Medium, or Wide sizes, or turns them Off. Side gutter
			patterns help keep the inkjets open by firing ink through
			them in a pattern outside the printed image area.
	•	Margin Settings
		• Space Between Prints (roll-fed media only) — sets the
			blank space between print jobs, between 0 and 10 inches
			(25 cm). A space of 3.25 inches (8.26 mm) or more is
			recommended to prevent the grit rollers from marking the
			media.
		• Right and Left Margin — sets the amount of blank space
			for the right and left margins, between 0.25 and 5 inches
			(6-127 mm) for roll-fed media, and between 0 and 5
			inches (0-127 mm) for rigid cut-sheet media.
			When you set the right and left margins to zero (edge-to-
			edge printing on cut-sheet media), the printer prompts
			you for an Overprint value. This is the distance beyond
			the edge of the media to print, to help avoid a blank strip
			if the sheet is slightly skewed, not perfectly rectangular,
			or other error is present.
	Note		If you load roll-fed media after printing on cut-sheet
			media, the printer automatically resets the right and

left margins to 0.25 inches (6 mm). You can still change them at any time.

• Leading Margin — defines the margin on the leading edge of cut-sheet media, between 0 and 15 inches (0-38 cm).

Menus 3-9