4.Using a 5 mm hex wrench, loosen the two set screws (shown below) that secure the vertical position of the move- able fence.

Fig. 2-13. Height adjustment screws

5.Place a long, flat, thin metal ruler on top of one column of table rollers.

6.Place the moveable fence arm on top of the metal ruler.

7.Press down on the arm until moveable arm is flat against the ruler.

8.Tighten both set screws.

The arm may move while tightening the set screws. Re- check the position after tightening.

9.Push the moveable arm back and forth across the width of the table to make sure that the arm does not contact the rollers.

Tip

To prevent thin flexible media from slipping under

 

the fence, the fence can be lowered to just under

 

the top surface of the rollers. In this case, use

 

extreme care when moving the fence across the

 

width of the media, to avoid striking the rollers.

 

 

Printing Tips

2-23