Print on envelopes

Envelopes must be printed from tray 1, which holds up to 10 envelopes. Printing performance depends on the construction of the envelope. Always test a few sample envelopes before purchasing a large quantity. For envelope specifications, see Supported paper and print media sizes on page 81 or go to www.hp.com/support/ljm9040mfp or www.hp.com/support/ljm9050mfp.

CAUTION: Envelopes with clasps, snaps, windows, coated linings, exposed self-stick adhesives, or other synthetic materials can severely damage the MFP. Do not use envelopes with pressure-sensitive adhesive.

Use the following basic steps to print on envelopes.

1.Load the envelopes in tray 1.

2.Change the fuser levers.

3.Send the print job.

Load envelopes in tray 1

1.Open tray 1, but do not pull out the extension. (Most envelopes feed best without the extension. However, oversize envelopes might need the extension.)

Figure 7-14Load envelopes in tray 1 (1 of 3)

2.Load up to 10 envelopes in the center of tray 1 with the side to be printed on facing up, and the return-address end toward the MFP. Slide the envelopes into the MFP as far as they will go without forcing them.

Figure 7-15Load envelopes in tray 1 (2 of 3)

110 Chapter 7

Print tasks

ENWW