Table
Menu item | Values and Description | ||
|
|
|
|
| Ping Results |
| Use this item to view the ping test status and results |
|
|
| using the control panel display. You can select the |
|
|
| following items: |
|
|
|
|
|
| Packets Sent | Shows the number of packets (0 - 65535) sent to the |
|
|
| remote host since the most recent test was initiated or |
|
|
| completed. |
|
|
|
|
|
| Packets Received | Shows the number of packets (0 - 65535) received from |
|
|
| the remote host since the most recent test was initiated |
|
|
| or completed. |
|
|
|
|
|
| Percent Lost | Shows the percent of ping test packets that were sent |
|
|
| with no response from the remote host since the most |
|
|
| recent test was initiated or completed. |
|
|
|
|
|
| RTT Min | Shows the minimum detected roundtrip- time (RTT), |
|
|
| from 0 to 4096 milliseconds, for packet transmission |
|
|
| and response. |
|
|
|
|
|
| RTT Max | Shows the maximum detected roundtrip- time (RTT), |
|
|
| from 0 to 4096 milliseconds, for packet transmission |
|
|
| and response. |
|
|
|
|
|
| RTT Average | Shows the average |
|
|
| 4096 milliseconds, for packet transmission and |
|
|
| response. |
|
|
|
|
|
| Ping In Progress | Shows whether a ping test is in progress. Yes indicates |
|
|
| a test in progress, and No indicates that a test |
|
|
| completed or was not run. |
|
|
|
|
|
| Refresh | When viewing the ping test results, this item updates |
|
|
| the ping test data with current results. Select Yes to |
|
|
| update the data, or No to maintain the existing data. |
|
|
| However, a refresh automatically occurs when the |
|
|
| menu times out or you manually return to the main |
|
|
| menu. |
|
|
|
|
Link Speed |
|
| The link speed and communication mode of the print |
|
|
| server must match the network. The available settings |
|
|
| depend on the device and installed print server. Select |
|
|
| one of the following link configuration settings: |
|
|
| CAUTION: If you change the link setting, network |
|
|
| communications with the print server and network |
|
|
| device might be lost. |
|
|
| Auto (default): The print server uses |
|
|
| to configure itself with the highest link speed and |
|
|
| communication mode allowed. If |
|
|
| either 100TX HALF or 10TX HALF is set depending on |
|
|
| the detected link speed of the hub/switch port. (A |
|
|
| 1000T |
|
|
| 10T Half: 10 Mbps, |
|
|
| 10T Full: 10 Mbps, |
|
|
| 100TX Half: 100 Mbps, |
|
|
| 100TX Full: 100 Mbps, |
|
|
| 100TX Auto: Limits |
|
|
| speed of 100 Mbps. |
|
|
|
|
32 Chapter 2 Control panel | ENWW |