Initial Setup menu
Administration > Initial Setup
The Initial Setup menu contains the
●Networking and I/O menu
●Fax Setup menu
●
NOTE: Values shown with "(default)" are the
Networking and I/O
Administration > Initial Setup > Networking and I/O
Table
Menu item | Values | Description | |
|
|
|
|
I/O Timeout | Select a value in the |
| range. The factory default |
| setting is 15 seconds. |
I/O timeout refers to the elapsed time before a print job fails. If the stream of data that the device receives for a print job gets interrupted, this setting indicates how long the device will wait before it reports that the job has failed.
Embedded Jetdirect | See Table |
|
|
EIO <X> Jetdirect |
|
|
|
Table
Menu item | Values and Description | ||
|
|
|
|
TCP/IP | Enable |
| Off: Disable the TCP/IP protocol. |
|
|
| On (default): Enable the TCP/IP protocol. |
|
|
|
|
| Host Name |
| An alphanumeric string, up to 32 characters, used to |
|
|
| identify the device. This name is listed on the |
|
|
| HP Jetdirect configuration page. The default host name |
|
|
| is NPIxxxxxx, where xxxxxx is the last six digits of the |
|
|
| LAN hardware (MAC) address. |
|
|
|
|
| IPV4 Settings | Config Method | Specifies the method by which TCP/IPv4 parameters |
|
|
| for the HP Jetdirect print server will be configured. |
|
|
| Bootp: Use BootP (Bootstrap Protocol) for automatic |
|
|
| configuration from a BootP server. |
|
|
| DHCP (Default): Use DHCP (Dynamic Host |
|
|
| Configuration Protocol) for automatic configuration |
|
|
| from a DHCPv4 server. If selected and a DHCP lease |
|
|
| exists, DHCP Release and DHCP Renew menus are |
|
|
| available to set DHCP lease options. |
|
|
| Auto IP: Use automatic |
|
|
| address in the form 169.254.x.x is assigned |
|
|
| automatically. |
|
|
|
|
26 Chapter 2 Control panel | ENWW |